WDX12G2.2
WDX12G2.2
WDX12G2.2
WDX12G2.2

WDX12G2.2

$469.95

-

Download Manual

 

California Prop 65 WARNING: Cancer and Reproductive Harm – www.p65warnings.ca.gov

Dont have a PayPal account? No problem, just click the yellow button and a small window will pop up. Scroll down and you'll see "Pay with Debit or Credit Card."
Categories: ,
000

Download Manual

 

California Prop 65 WARNING: Cancer and Reproductive Harm – www.p65warnings.ca.gov

Additional information

Weight 28 lbs
Dimensions 14.17 × 14.17 × 10.7 in

Our engineers at DB Drive have designed this subwoofer from the ground up to shake the ground up. The double stitched foam surround along with the die-cast aluminum vented basket allow for maximum excursion while the protective magnet cover gives the woofer a rugged yet stylish appearance.

  • 3.0″ Anodized aluminum high temperature voice coil
  • Non-Pressed paper cone
  • Double stitched foam surround
  • Dual poly-cotton dampeners
  • Die-cast aluminum vented basket
  • Rubber gasket trim ring
  • Large gauge compression terminals
  • Protective magnet cover

Recommended Amplifier – WDX2KG2

Physical Structure

Outside Diameter (A) 12.95″ (329mm)
Cutout Diameter (B) 11.34″ (288mm)
Mounting Depth (C) 7.58″ (192.5mm)
General Specifications
Structure 12″ (30.48cm) Woofer
Dynamic Power Handling 2500 Watts
Nominal Power Handling 1250 Watts
Impedanc Dual 2Ω Voice Coil
Parameters
Resonant Frequency (fs) 43.6Hz
D.C. Voice Coil Resistance (Re) 2 x 2Ω
Mechanical Quality Factor (Qms) 4.71
Electrical Quality Factor (Qes) 0.55
Total Quality Factor (Qts) 0.5
Equivalent Air Volume to Cms (Vas) 19.3 L
Mass of Diaphragm/Coil (Mms) 252.4 g
Force Factor (Bl) 22.3
Sound Pressure Level (SPL) 86.6dB

Recommended Enclosures

Woofer Cut-out 11.34″ (288mm)
Mounting Depth 7.58″ (192.5mm)
Sealed Box 1.88 ft3 (53.23L)
Vented Box 2.6 ft3 (73.62L)
Vent Area 20 in2 (129.03 cm2)
Vent Length 17″ (43.18 cm)
Tuning 33Hz
Dynamic Power 2500 Watts
Nominal Power 1250 Watts

Wiring Configuration

You can change the wiring configuration of your speakers (Series, Parallel and Series / Parallel) to match the impedance loads that maximizes the power output of you amplifier. Wiring the same woofer or multiple woofers in these three different wiring configurations will result in different impedance loads.

Series: Is the method of wiring of alternate positive with negative terminals (string method) (Illustration below)

Parallel:Is the method of wiring where you wire match 2 speaker terminals with positive to positive terminal and negative to negative. (Illustration below)

Series/Parallel: This configuration is a combination of both series and parallel. We recommend series for the terminal and parallel for the leads to amp. (Illustration below).

4 Ohm DVC Configuration

Related products