SPW12D4
$249.95
-
Additional information
Weight | 16 lbs |
---|---|
Dimensions | 13.97 × 13.97 × 7.48 in |
Our engineers at DB Drive have designed this subwoofer from the ground up to shake the ground up. The foam surround along with the die-cast aluminum vented basket allow for maximum excursion while the protective magnet cover gives the woofer a rugged yet stylish appearance.
- 2″ (101.6mm) 4 Layer Voice Coil w/ KSV Former
- Vac PP Sub Cone Structure with Butyl rubber Surround
- Inverted Vac PP Dome
- Ferrite Oxide magnet
- Anti-resonant Stamped Steel frame
- High Carbon Steel top and bottom plates
- Poly-Cotton Dampeners
- Compression Speaker Terminal
Recommended Amplifier – 2 Subs @ 1Ohm SPA12.1D
Recommended Amplifier – 1 Sub @ 2Ohms SPA6.1M
Physical Structure
Outside Diameter (A) | 12.50″ (317mm) |
Cutout Diameter (B) | 10.89″ (276.5mm) |
Mounting Depth (C) | 5.913″ (150mm) |
General Specifications | |
---|---|
Structure | 12″ (3.48cm) Woofer |
Dynamic Power Handling | 1250 Watts |
Nominal Power Handling | 600 Watts |
Impedance | Dual 4Ω Voice Coil |
Parameters | |
---|---|
Resonant Frequency (fs) | 23Hz |
D.C. Voice Coil Resistance (Re) | 6.4Ω |
Mechanical Quality Factor (Qms) | 5.79 |
Electrical Quality Factor (Qes) | 0.46 |
Total Quality Factor (Qts) | 0.43 |
Mass of Diaphragm/Coil (Mms) | 168.2 g |
Force Factor (Bl) | 18.4 |
Sound Pressure Level (SPL) | 86.2dB |
Recommended Enclosures
Woofer Cut-out | 10.89″ (276mm) |
Mounting Depth | 5.9″ (150mm) |
Sealed Box | 1.2 ft3 (33.98L) |
Vented Box | 1.6 ft3 (45.30L) |
? Vent Area | 7.4 in2 (121.264 cm2) |
? Vent Length | 18″ (45.72 cm) |
? Tuning | 26Hz |
Dynamic Power | 1250 Watts |
Nominal Power | 600 Watts |
Wiring Configuration
You can change the wiring configuration of your speakers (Series, Parallel and Series / Parallel) to match the impedance loads that maximizes the power output of you amplifier. Wiring the same woofer or multiple woofers in these three different wiring configurations will result in different impedance loads.
Series: Is the method of wiring of alternate positive with negative terminals (string method) (Illustration below)
Parallel:Is the method of wiring where you wire match 2 speaker terminals with positive to positive terminal and negative to negative. (Illustration below)
Series/Parallel: This configuration is a combination of both series and parallel. We recommend series for the terminal and parallel for the leads to amp. (Illustration below).