SPW10D4
SPW10D4
SPW10D4
SPW10D4

SPW10D4

$229.95

-

Download Manual

 

California Prop 65 WARNING: Cancer and Reproductive Harm – www.p65warnings.ca.gov

Dont have a PayPal account? No problem, just click the yellow button and a small window will pop up. Scroll down and you'll see "Pay with Debit or Credit Card."
Categories: ,
000

Download Manual

 

California Prop 65 WARNING: Cancer and Reproductive Harm – www.p65warnings.ca.gov

Additional information

Weight 15 lbs
Dimensions 11.22 × 11.22 × 7.086 in

Our engineers at DB Drive have designed this subwoofer from the ground up to shake the ground up. The foam surround along with the die-cast aluminum vented basket allow for maximum excursion while the protective magnet cover gives the woofer a rugged yet stylish appearance.

  • 2″ (101.6mm) 4 Layer Voice Coil w/ KSV Former
  • Vac PP Sub Cone Structure with Butyl rubber Surround
  • Inverted Vac PP Dome
  • Ferrite Oxide magnet
  • Anti-resonant Stamped Steel frame
  • High Carbon Steel top and bottom plates
  • Poly-Cotton Dampeners
  • Compression Speaker Terminal

Recommended Amplifier – 2 Subs @ 1Ohm WDX 1KG2

Recommended Amplifier – 1 Sub @ 2Ohms SPA6.1M

Physical Structure

Outside Diameter (A) 10.43″ (265mm)
Cutout Diameter (B) 9.06″ (230mm)
Mounting Depth (C) 5.24″ (133mm)
General Specifications
Structure 10″ (25.4cm) Woofer
Dynamic Power Handling 1250 Watts
Nominal Power Handling 600 Watts
Impedance Dual 4Ω Voice Coil
Parameters
Resonant Frequency (fs) 28.8Hz
D.C. Voice Coil Resistance (Re) 6.4Ω
Mechanical Quality Factor (Qms) 5.84
Electrical Quality Factor (Qes) 0.46
Total Quality Factor (Qts) 0.42
Mass of Diaphragm/Coil (Mms) 141.8 g
Force Factor (Bl) 19
Sound Pressure Level (SPL) 84.2dB

Recommended Enclosures

Woofer Cut-out 9.06″ (230mm)
Mounting Depth 5.24″ (133mm)
Sealed Box 0.9 ft3 (25.48L)
Vented Box 1.25 ft3 (35.39L)
? Vent Area 7.4 in2 (121.264 cm2)
? Vent Length 17″ (43.18 cm)
? Tuning 30Hz
Dynamic Power 1250 Watts
Nominal Power 600 Watts

Wiring Configuration

You can change the wiring configuration of your speakers (Series, Parallel and Series / Parallel) to match the impedance loads that maximizes the power output of you amplifier. Wiring the same woofer or multiple woofers in these three different wiring configurations will result in different impedance loads.

Series: Is the method of wiring of alternate positive with negative terminals (string method) (Illustration below)

Parallel:Is the method of wiring where you wire match 2 speaker terminals with positive to positive terminal and negative to negative. (Illustration below)

Series/Parallel: This configuration is a combination of both series and parallel. We recommend series for the terminal and parallel for the leads to amp. (Illustration below).

4 Ohm DVC Configuration

Related products