Download Manual


California Prop 65 WARNING: Cancer and Reproductive Harm – www.p65warnings.ca.gov

Out of stock


Download Manual


California Prop 65 WARNING: Cancer and Reproductive Harm – www.p65warnings.ca.gov

Additional information

Weight 19 lbs
Dimensions 10.43 × 10.43 × 10.11 in

Our engineers at DB Drive have designed this subwoofer from the ground up to shake the ground up. The double stitched foam surround along with the die-cast aluminum vented basket allow for maximum excursion while the protective magnet cover gives the woofer a rugged yet stylish appearance.

  • 2″ BASV high temperature voice coil
  • Non-Pressed paper cone
  • Double stitched foam surround
  • Dual poly-cotton dampeners
  • Die-cast aluminum vented basket
  • Rubber gasket trim ring
  • Large gauge compression terminals
  • Shallow Mounting Depth

Recommended Amplifier – WDX1KG2

Physical Structure

Outside Diameter (A) 8.78″ (223mm)
Cutout Diameter (B) 7.32″ (186mm)
Mounting Depth (C) 4.47″ (113.5mm)
General Specifications
Structure 8″ (20.32cm) Woofer
Dynamic Power Handling 700 Watts
Nominal Power Handling 350 Watts
Impedance Dual 4Ω Voice Coil
Resonant Frequency (fs) 40.082Hz
D.C. Voice Coil Resistance (Re) 6.16Ω
Mechanical Quality Factor (Qms) 3.047
Electrical Quality Factor (Qes) 0.589
Total Quality Factor (Qts) 0.493
Equivalent Air Volume to Cms (Vas) 8.876 L
Mass of Diaphragm/Coil (Mms) 101.97 g
Force Factor (Bl) 16.391
Sound Pressure Level (SPL) 81.7dB

Recommended Enclosures

Woofer Cut-out 7.32″ (186mm)
Mounting Depth 4.47″ (113.5mm)
Sealed Box 0.4 ft3 (11.32L)
Vented Box 1.13 ft3 (31.99L)
? Vent Area 10 in2 (64.51 cm2)
? Vent Length 22″ (55.88 cm)
? Tuning 33Hz
Dynamic Power 700 Watts
Nominal Power 350 Watts

Wiring Configuration

You can change the wiring configuration of your speakers (Series, Parallel and Series / Parallel) to match the impedance loads that maximizes the power output of you amplifier. Wiring the same woofer or multiple woofers in these three different wiring configurations will result in different impedance loads.

Series: Is the method of wiring of alternate positive with negative terminals (string method) (Illustration below)

Parallel:Is the method of wiring where you wire match 2 speaker terminals with positive to positive terminal and negative to negative. (Illustration below)

Series/Parallel: This configuration is a combination of both series and parallel. We recommend series for the terminal and parallel for the leads to amp. (Illustration below).

4 Ohm DVC Configuration