WDX10G1.4

Name: WDX10G1.4
SKU: 19607
Availability: InStock

$299.98

Download Manual

California Prop 65 WARNING: Cancer and Reproductive Harm – www.p65warnings.ca.gov

Dont have a PayPal account? No problem, just click the yellow button and a small window will pop up. Scroll down and you'll see "Pay with Debit or Credit Card."

Categories: Subwoofers, WDXG1 Series

Description
Additional information

Download Manual

California Prop 65 WARNING: Cancer and Reproductive Harm – www.p65warnings.ca.gov

Additional information

Weight	20 lbs
Dimensions	12.24 × 12.24 × 8.5 in

Our engineers at DB Drive have designed this subwoofer from the ground up to shake the ground up. The double stitched foam surround along with the die-cast aluminum vented basket allow for maximum excursion while the protective magnet cover gives the woofer a rugged yet stylish appearance.

3″ BASV High Temperature Voice coil
Non-Pressed paper cone
Double stitched foam surround
Dual poly-cotton dampeners
Die-cast aluminum vented basket
Rubber gasket trim ring
Large gauge compression terminals
Protective magnet cover

Recommended Amplifier – WDX2KG2

Physical Structure

Outside Diameter (A)	10.86″ (276mm)
Cutout Diameter (B)	9.15″ (156.21mm)
Mounting Depth (C)	6.15″ (156.210mm)

General Specifications
Structure	10″ (25.4cm) Woofer
Dynamic Power Handling	2000 Watts
Nominal Power Handling	1000 Watts
Impedance	Dual 4Ω Voice Coil

Parameters
Resonant Frequency (fs)	41.63Hz
D.C. Voice Coil Resistance (Re)	3.2 x 3.2Ω
Mechanical Quality Factor (Qms)	3.156
Electrical Quality Factor (Qes)	0.582
Total Quality Factor (Qts)	0.492
Equivalent Air Volume to Cms (Vas)	9.79 L
Mass of Diaphragm/Coil (Mms)	289.93 g
Force Factor (Bl)	14.437
Sound Pressure Level (SPL)	82.7 dB

Recommended Enclosures

Woofer Cut-out	9.15″ (232.41mm)
Mounting Depth	6.15″ (156.21mm)
Sealed Box	1 ft³ (28.32L)
Vented Box	1.2 ft³ (33.98L)
? Vent Area	7.7 in² (45.6 cm²)
? Vent Length	11″ (27.94cm)
? Tuning	36Hz
Dynamic Power	2000 Watts
Nominal Power	1000 Watts

Wiring Configuration

You can change the wiring configuration of your speakers (Series, Parallel and Series / Parallel) to match the impedance loads that maximizes the power output of you amplifier. Wiring the same woofer or multiple woofers in these three different wiring configurations will result in different impedance loads.

Series: Is the method of wiring of alternate positive with negative terminals (string method) (Illustration below)

Parallel:Is the method of wiring where you wire match 2 speaker terminals with positive to positive terminal and negative to negative. (Illustration below)

Series/Parallel: This configuration is a combination of both series and parallel. We recommend series for the terminal and parallel for the leads to amp. (Illustration below).