WDX10 G0.4

WDX10 G0.4




Download Manual


California Prop 65 WARNING: Cancer and Reproductive Harm – www.p65warnings.ca.gov

Dont have a PayPal account? No problem, just click the yellow button and a small window will pop up. Scroll down and you'll see "Pay with Debit or Credit Card."


Download Manual


California Prop 65 WARNING: Cancer and Reproductive Harm – www.p65warnings.ca.gov

Additional information

Weight 25 lbs
Dimensions 11.629 × 16.5 × 8.03 in

Our engineers at DB Drive have designed this subwoofer from the ground up to shake the ground up. The foam surround along with the die-cast aluminum vented basket allow for maximum excursion while the protective magnet cover gives the woofer a rugged yet stylish appearance.

  • 2.5″ High Temperature Voice coil
  • Reinforced paper cone
  • Dual poly-cotton dampeners
  • Stamped Cast basket
  • Rubber gasket trim ring
  • Large gauge compression terminals
  • Protective magnet cover

Physical Structure

Outside Diameter (A) 10.70″ (272mm)
Cutout Diameter (B) 9.07″ (230.57mm)
Mounting Depth (C) 5.84″ (148.50mm)
General Specifications
Structure 10″ (25.4cm) Woofer
Dynamic Power Handling 1000 Watts
Nominal Power Handling 500 Watts
Impedance Dual 4Ω Voice Coil
Resonant Frequency (fs) 38.074
D.C. Voice Coil Resistance (Re)  3.4 Ω X 2
Mechanical Quality Factor (Qms) 2.370
Electrical Quality Factor (Qes) 0.580
Total Quality Factor (Qts) 0.466
Equivalent Air Volume to Cms (Vas) 18.768 L
Mass of Diaphragm/Coil (Mms) 174.262 g
Force Factor (Bl) 11.051
Sound Pressure Level (SPL) 84.4 dB

Recommended Enclosures

Woofer Cut-out 9.07″ (230.57mm)
Mounting Depth 5.84″ (148.50mm)
Sealed Box 0.8cu ft (22.65 L)
Vented Box 1.39cu ft (39.36L)
Vent Area 12.57 in2 (81.57 cm2)
Vent Length 13″ (33.02 cm)
Tuning 40Hz
Dynamic Power 1000 Watts
Nominal Power 500 Watts

4 Ohm DVC wiring Configuration

You can change the wiring configuration of your speakers (Series, Parallel and Series / Parallel) to match the impedance loads that maximizes the power output of you amplifier. Wiring the same woofer or multiple woofers in these three different wiring configurations will result in different impedance loads.

Series: Is the method of wiring of alternate positive with negative terminals (string method) (Illustration below)

Parallel:Is the method of wiring where you wire match 2 speaker terminals with positive to positive terminal and negative to negative. (Illustration below)

Series/Parallel: This configuration is a combination of both series and parallel. We recommend series for the terminal and parallel for the leads to amp. (Illustration below).