WDX10G2F-4

WDX10G2F-4

$499.99

Download Manual

California Prop 65 WARNING: Cancer and Reproductive Harm – www.p65warnings.ca.gov

Out of stock

Categories: Subwoofers, WDXG2 Shallow Series

Description
Additional information

Download Manual

California Prop 65 WARNING: Cancer and Reproductive Harm – www.p65warnings.ca.gov

Additional information

Weight	25 lbs
Dimensions	12.2 × 12.2 × 8.74 in

Our engineers at DB Drive have designed this subwoofer from the ground up to shake the ground up. The double stitched foam surround along with the die-cast aluminum vented basket allow for maximum excursion while the protective magnet cover gives the woofer a rugged yet stylish appearance.

2.5″ Anodized aluminum high temperature voice coil
Non-Pressed paper cone
Double stitched foam surround
Dual poly-cotton dampeners
Die-cast aluminum vented basket
Rubber gasket trim ring
Large gauge compression terminals
Shallow Mounting Depth

Recommended Amplifier – WDX2KG2

Physical Structure

Outside Diameter (A)	10.98″ (279mm)
Cutout Diameter (B)	9.44″ (240mm)
Mounting Depth (C)	5.12″ (155mm)

General Specifications
Structure	10″ (16.5cm) Woofer
Dynamic Power Handling	1000 Watts
Nominal Power Handling	500 Watts
Impedance	Dual 4Ω Voice Coil

Parameters
Resonant Frequency (fs)	34.648Hz
D.C. Voice Coil Resistance (Re)	7.04Ω
Mechanical Quality Factor (Qms)	4.285
Electrical Quality Factor (Qes)	0.839
Total Quality Factor (Qts)	0.702
Equivalent Air Volume to Cms (Vas)	19.86 L
Mass of Diaphragm/Coil (Mms)	171.014 g
Force Factor (Bl)	17.676
Sound Pressure Level (SPL)	81.64dB

Recommended Enclosures

Woofer Cut-out	9.44″ (240mm)
Mounting Depth	5.90″ (150mm)
Sealed Box	0.5 ft³ (24.48L)
Vented Box	1.77 ft³ (50.12L)
? Vent Area	17 in² (109.67 cm²)
? Vent Length	17″ (43.18 cm)
? Tuning	33Hz
Dynamic Power	1000 Watts
Nominal Power	500 Watts

Wiring Configuration

You can change the wiring configuration of your speakers (Series, Parallel and Series / Parallel) to match the impedance loads that maximizes the power output of you amplifier. Wiring the same woofer or multiple woofers in these three different wiring configurations will result in different impedance loads.

Series: Is the method of wiring of alternate positive with negative terminals (string method) (Illustration below)

Parallel:Is the method of wiring where you wire match 2 speaker terminals with positive to positive terminal and negative to negative. (Illustration below)

Series/Parallel: This configuration is a combination of both series and parallel. We recommend series for the terminal and parallel for the leads to amp. (Illustration below).